If you’re hearing the sound of water running in your bathroom, you could have a leaky toilet. A common place where leaks occur is in the toilet tank. Leaky fill valves, tank parts and flapper valves are some of the reasons you may be in need of toilet leak repair.
cpecialict.ru plumbing professionals provide 24-hour emergency toilet repair and replacement services. But if you prefer to fix toilet leak yourself, here are some basic repair options.
Before you tackle anything, drain the toilet. Turn off the supply valve and flush the toilet. Disconnect the supply line from the tank and soak up the remaining water inside the tank until it's completely dry.
Replace the fill valve. Before you buy a new fill valve, remove the old one and take it to the store so that you get the right replacement part. Install the new fill valve according to the instructions and attach the refill tube. Re-attach the supply line to the fill valve. Turn the shut-off valve back on and allow the tank to fill. You can adjust the water level using the screw on the float (FluidMaster 400) so the water level in the tank is approximately one inch below the overflow tube and check for leaks.
Replace toilet gaskets. Your toilet has two gaskets that seal the bolts that hold the tank to the bowl. It also has a gasket that seals the flush valve, as well as one that seals the water passage between the tank and the bowl, called a tank bowl gasket. If the tank bolt washers fail, you'll see water on the floor under the tank. If the flush valve gasket or the tank bowl gasket fails, you'll see water between the seat and the tank.
If you are making these types of repairs, at this point you need to rebuild the toilet tank while you have everything apart. First you must shut off the water to the toilet.
If the leak is not coming from your tank, the toilet may be leaking around the base. This leak occurs when you flush the toilet. Tightening the toilet bolts (Johnny bolts) and replacing the wax ring are two ways to fix this problem, but make sure the leak is in fact coming from the base.
Tightening the toilet bolts might not stop a leak if the wax ring is not sealing properly. You may need to replace the wax ring. Before the toilet is removed, shut off the water and drain the toilet and tank. Remove the toilet from the floor and lay it on its side. Remove the old wax ring and clean around the area. Install the new wax ring on the base of the toilet. Set the toilet back in its original position. Tighten down the toilet bolts, alternating from bolt to bolt. Use a box or open end wrench, but do not overtighten. Turn the water on and check for leaks around the base. You will need to caulk around the base, but you might want to wait a few days to make sure the leak has in fact been fixed and no more water is appearing around the base.
If you have a toilet that always seems to clog or run, or if you need toilet repair or replacement, cpecialict.ru's licensed plumbing specialists can solve the problem.